Computer restart again before entering the operating system how the matter?
Users questions: I thought it was poisoned, we reload the system. Can restart the problem still occurs. Is how going on?
Experts answer: error script debugging. Please click on Tools, interent options, advanced, find Disable script debugging check mark in the two before. Restart the computer .. the reason I call the right health Brain. Property. Senior. Startup and Recovery. Set. The following three hook cancel. Not yet. If you exclude the virus. Is. Power skill small. Bad power supply can not provide enough power, when the system equipment, increased power consumption larger, poor power supply voltage output will be drastically reduced, ultimately cause the system to work For instability, the phenomenon appears automatically restart. Voltage fluctuations may also cause excessive damage to the hard disk and other devices. Memory errors cause the system to restart the probability relatively large. Memory and the graphics poor contact with the socket case .. way clean memory and graphics cards with rubber finger .. check the CPU fan is running Normal power outlet .. poor contact and air-conditioning, refrigerators and other large electrical power line to share a plate inserted. .. The last replacement outlet box inside another check whether there is loose. Computer suddenly restart, after the blue screen "STOP: c0000218 (RegistryFileFailur e) ", how no admission to the operating system. whether it is safe mode or Last Known Good Configuration is not available, but until it is normal to use. Answer:" STOP: c0000218 (RegistryFileFailure) "is a typical error message , Causing the error is due to hard disk errors or disk damage. Solution as follows: 1. WindowsXP CD from your computer. If prompted, select to start the computer from the CD to select any of the options. 2. When you choose the "Repair or Recovery", press R. This will start Microsoft Recovery Console. 3. When prompted, type the administrator password. If the administrator password is blank, press Enter. 4. Use the chkdsk command-line tool to check the hard disk. At the command prompt, type chkdsk * r, and then press Enter. Ordinary After operating the above circumstances, there will be no question, of course, if the hard disk physical damage occurs, such an approach would not be effective, if this is the case, we can only replace the hard drive.