My computer blue screen and then boot to the desktop and then automatically restart on the desktop
[Users questions | Browse:84 | Favorites]
Users questions: My computer would blue screen and then boot to the desktop and then blue screen and then automatically restart the system after the re-issue of Bahrain Bahrain is also now start to desktop systems do not move the mouse all the normal security mode heroes who told I ask how to address the high points to solve the BIOS battery discharge
Experts answer: (out of recovery BIOS Factory default) recommended plug about graphics cards, memory, clean up health and polished graphics card, memory of the finger. Not start the operating system of diagnostic methods are as follows. First check the boot, your computer is started the operating system. If you start the operating system crashes, blue screen or auto restart Then the hard drive's partition table and master boot record normal, excluding the hard disk partition table is damaged, damaged hard disk master boot record, partition hard drive failure marks the end of loss and other reasons. Then use the following method for diagnosis. Step 1: First, start the computer using safe mode to see if it can start, if not start, you may Is infected, the system file is missing, damaged operating system, hard disk has bad sectors, there is a conflict or a hardware device hardware problems, go to Step 4; If you can start safe mode, it may be incompatible with the system hardware drivers, operating system problems or infections caused by viruses. Step 2: Then run antivirus software If a virus, it may be caused by a virus, antivirus, restart the computer, if not normal, you need to reinstall your operating system. Step 3: If no virus is detected, you can use the operating system comes with a "System Restore" feature, the system restore, restore after the system is normal, failure is by System damage caused. If the fault persists, the device driver may be incompatible with the system caused; then the sound card, graphics cards, network drivers and other equipment removed, and then install the drivers one by one, each installation of a device to reboot the computer to check the Which device driver is causing the Failure, check out, download the new version of the failed device driver, then install it. Step 4: If you can not start in safe mode, then use the installation CD to reinstall the operating system. If you can properly install the operating system, turn step 7; If you install the operating system failure, such as crashes, blue screen, Restart the system can not be installed as a result, it is a hardware problem or bad hardware cause. Step 5: Then clean the computer of dust, clean the memory, graphics and other equipment finger, re-install the memory and other devices, then re-install the operating system, if properly installed system, it is bad Caused the failure. Step 6: If you still can not install the system, the problem may be caused by hardware failure. Then check with the substitution of hardware failure, can be found after the replacement of hardware. Step 7: If you can properly install the operating system and installed the fault disappears, it is a system file corruption caused by the failure. 8 Step: If you install the operating system, the fault still, it may be caused by bad sectors hard disk or device driver is not compatible with the system caused by. Start your computer with safe mode, if not start, it is the hard disk has bad sectors caused by the failure. Then use Disk Utility repair bad sectors can NDD. Step 9: If Can start safe mode, the device driver is not compatible with the system caused. Then the sound card, graphics cards, network cards and other equipment removed, and then install the drivers one by one, install a start time to check which device driver is causing the failure. Check out, download a new version of the device driver failure Sequence, and then install it.
Experts answer: (out of recovery BIOS Factory default) recommended plug about graphics cards, memory, clean up health and polished graphics card, memory of the finger. Not start the operating system of diagnostic methods are as follows. First check the boot, your computer is started the operating system. If you start the operating system crashes, blue screen or auto restart Then the hard drive's partition table and master boot record normal, excluding the hard disk partition table is damaged, damaged hard disk master boot record, partition hard drive failure marks the end of loss and other reasons. Then use the following method for diagnosis. Step 1: First, start the computer using safe mode to see if it can start, if not start, you may Is infected, the system file is missing, damaged operating system, hard disk has bad sectors, there is a conflict or a hardware device hardware problems, go to Step 4; If you can start safe mode, it may be incompatible with the system hardware drivers, operating system problems or infections caused by viruses. Step 2: Then run antivirus software If a virus, it may be caused by a virus, antivirus, restart the computer, if not normal, you need to reinstall your operating system. Step 3: If no virus is detected, you can use the operating system comes with a "System Restore" feature, the system restore, restore after the system is normal, failure is by System damage caused. If the fault persists, the device driver may be incompatible with the system caused; then the sound card, graphics cards, network drivers and other equipment removed, and then install the drivers one by one, each installation of a device to reboot the computer to check the Which device driver is causing the Failure, check out, download the new version of the failed device driver, then install it. Step 4: If you can not start in safe mode, then use the installation CD to reinstall the operating system. If you can properly install the operating system, turn step 7; If you install the operating system failure, such as crashes, blue screen, Restart the system can not be installed as a result, it is a hardware problem or bad hardware cause. Step 5: Then clean the computer of dust, clean the memory, graphics and other equipment finger, re-install the memory and other devices, then re-install the operating system, if properly installed system, it is bad Caused the failure. Step 6: If you still can not install the system, the problem may be caused by hardware failure. Then check with the substitution of hardware failure, can be found after the replacement of hardware. Step 7: If you can properly install the operating system and installed the fault disappears, it is a system file corruption caused by the failure. 8 Step: If you install the operating system, the fault still, it may be caused by bad sectors hard disk or device driver is not compatible with the system caused by. Start your computer with safe mode, if not start, it is the hard disk has bad sectors caused by the failure. Then use Disk Utility repair bad sectors can NDD. Step 9: If Can start safe mode, the device driver is not compatible with the system caused. Then the sound card, graphics cards, network cards and other equipment removed, and then install the drivers one by one, install a start time to check which device driver is causing the failure. Check out, download a new version of the device driver failure Sequence, and then install it.
- What are the features the computer network?
- Describes the basic components of computer work
- How to determine your computer does not svchost trojan, how to delete
- Script virus malicious Web site how to do?
- Does the computer have universal health drive
- Fn key on a laptop how to use what is useful
- Help: This is a computer problem, how to repair?
- How to identify computer hardware is good or bad
- How to set double click to open shortcut icon?
- Internet system for personal use to restore it?
- This information provided by the users.Thanks!
Computer Knowledge Copyright 2005-2015 All Rights Reserved.