My monitor has been magnetized, and now each boot color cast
Users questions: My monitor has been magnetized, and now each boot color cast, but with some time to normal, this is why? Where broken? How to do?
Experts answer: Fault Analysis and Treatment: Because the display is still new, can not be the reason CRT aging. Try one of the computers will be completely closed (the so-called Is completely shut down the host and the display of the power plug), over ten minutes after the power plug in the power plug and then open the monitor, hear a slight "bang", based on experience, I know that is normal degaussing circuit into the system and then use Notepad to open a blank file and maximization (the main If the whole screen white form in order to observe the color cast situation), they discovered that the display back to normal, no color cast out. It seems the monitor is good, why there will be color cast so? Due to the monitor support green energy-saving features, along with more difficult to turn the monitor (monitor the switch in the back), we Usually only the relevant host (using Win98 automatic shutdown mode) rather than off the monitor. The display of work by the energy state to state is handled without degaussing (demagnetization resistance because of energy-saving state or in a hot state), so long failed to monitor the degaussing circuit for degaussing at the display Management, so that the display screen due to chronic lack of color cast caused by the phenomenon of degaussing. Another unit of the engine room near the medical equipment, usually a strong magnetic field may arise, resulting in displays, show the phenomenon of color cast. To remind everyone, if possible, should be shut down after a day, while the monitor off The power switch. Should be thin in some of the data line circuit for a color cast caused by it